ZyXEL Communications GS1920-48HPv2, Руководство пользователя

Страница: 351 / 432

Chapter 40 Access Control
GS1920v2 Series User’s Guide
351
The following table describes the labels in this screen.
40.3.2 Ena b ling / Disa b ling Se nding o f SNMP Tra ps o n a Po rt
From the
SNMP > Tra p G ro up
screen, click
Po rt
to view the screen as shown. Use this screen to set
whether a trap received on the port(s) would be sent to the SNMP manager.
Fig ure 255
Management > Access Control > SNMP > Trap Group > Port
Table 171 Management > Access Control > SNMP > Trap Group
LABEL DESC RIPTIO N
Trap Destination IP Select one of your configured trap destination IP addresses. These are the IP addresses of the
SNMP managers. You must first configure a trap destination IP address in the
SNMP Se tting
screen.
Use the rest of the screen to select which traps the Switch sends to that SNMP manager.
Type Select the categories of SNMP traps that the Switch is to send to the SNMP manager.
Options Select the individual SNMP traps that the Switch is to send to the SNMP station. See SNMP Traps
on page 359 for individual trap descriptions.
The traps are grouped by category. Selecting a category automatically selects all of the
category’s traps. Clear the check boxes for individual traps that you do not want the Switch
to send to the SNMP station. Clearing a category’s check box automatically clears all of the
category’s trap check boxes (the Switch only sends traps from selected categories).
Apply Click
Apply
to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the
Sa ve
link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click
C a nc e l
to begin configuring this screen afresh.