ZyXEL Communications GS1920-48HPv2, Руководство пользователя

Страница: 37 / 432

Chapter 3 Hardware Panels
GS1920v2 Series User’s Guide
37
WARNING ! To a vo id po ssib le e ye injury, do no t lo o k into a n o pe ra ting
fib e r- o ptic m o dule ’s c o nne c to rs.
• Type: SFP connection interface
• Connection speed: 100/1000 Mbps per second
3.1.3.1 Tra nsc e ive r Insta lla tio n
Use the following steps to install an SFP transceiver.
1
Insert the transceiver into the slot with the exposed section of PCB board facing down.
2
Press the transceiver firmly until it clicks into place.
3
The Switch automatically detects the installed transceiver. Check the LEDs to verify that it is functioning
properly.
4
Close the transceiver’s latch (latch styles vary).
5
Connect the fiber optic cables to the transceiver.
Fig ure 15
Transceiver Installation Example
Fig ure 16
Connecting the Fiber Optic Cables
3.1.3.2 Tra nsc e ive r Re m o va l
Use the following steps to remove an SFP transceiver.
1
Remove the fiber optic cables from the transceiver.
2
Open the transceiver’s latch (latch styles vary).
Note: Make sure the transceiver’s latch is pushed all the way down, so the transceiver can be
pulled out successfully.
3
Pull the transceiver out of the slot.
Note: Do NOT pull the transceiver out by force. You could damage it.