ZyXEL Communications GS1920-48HPv2, Руководство пользователя

Страница: 300 / 432

Chapter 33 Link Layer Discovery Protocol (LLDP)
GS1920v2 Series User’s Guide
300
33.6.1 Ba sic TLV Se tting
Use this screen to configure Basic TLV settings. Click
Adva nc e d Applic a tio n
>
LLDP > LLDP C o nfig ura tio n
(C lic k He re ) > Ba sic TLV Se tting
to display the screen as shown next.
Fig ure 215
Advanced Application > LLDP > LLDP Configuration> Basic TLV Setting
The following table describes the labels in this screen.
Port This displays the Switch’s port number. * means all ports.
* Use this row to make the setting the same for all ports. Use this row first and then make
adjustments to each port if necessary.
Changes in this row are copied to all the ports as soon as you make them.
Admin Status Select whether LLDP transmission and/or reception is allowed on this port.
• Disable - not allowed
• Tx-Only - transmit only
• Rx-Only - receive only
• Tx-Rx - transmit and receive
Notification Select whether LLDP notification is enabled on this port.
Apply Click
Apply
to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the
Sa ve
link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click
C a nc e l
to begin configuring this screen afresh.
Table 138 Advanced Application > LLDP > LLDP Configuration
LABEL DESC RIPTIO N
Table 139 Advanced Application > LLDP > LLDP Configuration > Basic TLV Setting
LABEL DESC RIPTIO N
Port This displays the Switch’s port number.
* Use this row to make the setting the same for all ports. Use this row first and then make
adjustments to each port if necessary.
Changes in this row are copied to all the ports as soon as you make them.