TOWA LCM1010, Руководство по эксплуатации

Страница: 256 / 552

LCM 1010 Instruction Manual
7 MANUAL OPERATION
Key Switch
RESET button
A CAUTION
6. Press the [RESET] button on the main operation
panel.
- When pressed several times, the error is cleared
and the buzzer stops sounding.
- The computer boots, the intelligent system
automatically starts up and the System Menu
screen appears.
*7. Select the “PRIMARY STATUS” on the “System
Menu” screen.
- The Primary Status screen will be displayed.
1) Turn ON the servo power o f the Resin Module.
2) Turn ON the servo and Heater power o f the Press
Module.
3) Turn ON the servo and Preheater power o f the
Handling Module.
* Refer to the “ 8.2.4 Primary Status” .
After power on, it takes a long time for the mold and preheater to
reach a set temperature.
Measure the surface temperature of the mold and preheater with a
thermometer and wait until stabilized.
A CAUTION
A
CAUTION
8. Carry out press return to origin process.
Refer to the “7.2.2. Press Origin Return” .
Right after the resin fed into the mold c%nolded, do not move it as it
is for a while, until resin hardening cpmpleted.
If the press is closed, perform the origin return after the clamp goes
down and the mold is opened a little. 3,f
Remove moldings left in the die.'Release L/F memories of each part
on the L/F MEMORY MONITOR” of the “Aute Operation” screen.
Refer to the “8.2.2 Main Operations Screen”.
9. Press the [RESET] button on the main operation panel.
Before starting production operation, measure surface temperature
of die and preheaters with a thermometer.
There are some cases in which temperature monitor reaches set
temperature on the Auto Operation screen but the surface
temperature of die or preheater does not go up enough.
10. Release film is sent, and restart production operation.
TCWA 7-11