Toshiba Strata AirLink DK40i, Руководство по установке и обслуживанию

Страница: 202 / 724

DK424 Installation
RCTUA, RCTUBA/BB, RCTUC/D, RCTUE/F Common Control Units
5-50
Strata DK I&M 6/00
➤
To install an RRCS onto RCTUA, RCTUBA/BB, RCTUC/D, or RCTUE/F
➤
Mate RRCS connectors J1, J2, J3, and J4 (see Figure 5-31 ) with the applicable RCTU PCB.
Apply firm, even pressure to the RRCS to ensure proper mating of the connectors.
RCTUA connectors are P2, P3, P4, P5. (See Figure 5-32 .)
RCTUBA connectors are P3, P4, P5, P6. (See Figure 5-33 .)
RCTUC connectors are P3, P4, P5, and P6; RCTUD connectors P5, P6, P7, P8. (See Figures
5-35 , 5-36 .)
RCTUE connectors are P6, P7, and P9; RCTUF3 are P8, P9, and P10. (See Figures 5-37 ,
5-38 .)
Note
The RRCS connectors on these PCBs are positioned to allow installation of the RRCS
only in the proper position.
The combined RCTUC/D and RCTUE/F common control unit can support up to 24 DTMF
receiver circuits. Both the RCTUC or RCTUE and the RCTUD or F PCBs can be equipped with
the RRCS (4, 8, or 12).
RRCSs can be installed on both the RCTUC or RCTUE and the RCTUD or RCTUF at the same
time. If only one RRCS is installed, the RRCS must be on the RCTUC. Always install the RRCS
on the RCTUC before RCTUD and the RCTUE before RCTUF.
Note
The RRCS connectors on these PCBs are positioned to allow installation of the RRCS
only in the proper position.
RSIU Installation
See “DK424 and DK424i RCIU1 or RCIU2 Installation” on Page 9-27 .
J1
J2
J3
J4
1395
Figure 5-31 RRCS Printed Circuit Board