Toshiba Strata AirLink DK40i, Руководство по установке и обслуживанию

Страница: 407 / 724

Universal Slot PCBs
RDTU – T1 Interface Unit
Strata DK I&M 6/00
9-63
Universal Slot PCBs
RMCU/RCMS Programming
Program 03: Specify code 19 for the RMCU slot.
Program *11, *12, *13: Refer to the E911, CAMA trunk tab in the Strata DK Programming
Manual and set Programs *11, *12, and *13 as required.
Note
Program *10 is required only when using third-party adjunct CAMA interface and not
used with RMCU CAMA interface.
Table 9-21 LED Indications (Normal Operation)
Status NB LED CB LED
1
No network connection.
RMCU is in stand-by mode.
On Off
2
Network connected.
RMCU is in stand-by mode.
Off
1
1. If the NB LED stays On, even if the modular connector of the network is connected, check the following:
Tip and Ring could be reversed.
Network could be busy.
Off
3
Network is in stand-by mode and the RMCU is off
hook.
Network is connected and the RMCU MF sending
dial tone.
Off On
4 Network is seizing and the RMCU is off- hook. Flashing On
5
Network is connecting, before ANI is sent, and the
RMCU is sending.
Network is connecting and the RMCU is
communicating.
On On
6
Network is disconnecting first and then the RMCU
disconnects.
On then Off On then Off
7
RMCU is disconnecting first and then the network
disconnects.
On then Off On then Off