7 - SUPPORTING FRAME AND FENCE FOR PARALLEL CUTS: USE AND
ADJUSTMENT
EN
Pag.
22/26
- Cap.
7
THIS MANUAL IS PROPERTY OF SCM INDUSTRIA S.P.A - ANY TOTAL OR PARTIAL REPRODUCTION IS STRICTLY FORBIDDEN
DANGER-WARNING:
the front end of the line must never protrude from the floor at the end (F fig. 7.24-5A), but must
arrive at an imaginary line (G fig. 7.24-5A) that starts from the first tooth of the blade and slide
forward to 45°. This is to prevent the ascent saw teeth to grab the piece and cast against the
operator.
DANGER-WARNING:
use of longitudinal guide (2 fig. 7.24-5A) to prevent backlash during transverse cut.
(4) = direction of piece feed
During the cut via the transverse guide (3 fig. 7.24-5A), the front end of the longitudinal guide (2 fig.
7.24-5A) must be positioned before the front end of the blade (1 fig. 7.24-5A) or not in contact with
the piece.
DANGER-WARNING:
never put the hands near the saw blade-engraver; always use a pusher.
The machine is supplied with a pusher (R fig. 7.24-5A) and with a knob (B fig. 7.24-5A). The knob (B fig. 7.24-5A)
may be applied to pushers of different size, screwing it on with the screws provided.
Depending on the dimensions of the piece to be machined, select the most suitable type of pusher.
Use for tall and narrow pieces.
Use for short and narrow pieces.
