9a - OPERATIONS AND ADJUSTMENTS OF SPINDLE
EN
Pag.
22/45
- Cap.
9a
THIS MANUAL IS PROPERTY OF SCM INDUSTRIA S.P.A - ANY TOTAL OR PARTIAL REPRODUCTION IS STRICTLY FORBIDDEN
9A.33.2 ADJUST SPINDLE MOULDER HOOD FOR MOULDING
WITH REMOVAL.
(cu_9a-33-2_0.0)
-
After loosening knobs (G, C fig. 9.33-2) move the entire hood- fence unit to the most suitable position for
the depth of cut required, then tighten the knobs.
-
The fence halves (A and B fig. 9.33-2) must be as near the tool as possible (about 2-3 mm). To make this
adjustment loosen handles (D fig. 9.33-2) behind the fence halves.
For further micrometric adjustment of the depth of cut set the fence half (A fig. 9.33-2) as follows:
-
slacken the knob (C fig. 9.33-2).
-
Turn knob (E fig. 9.33-2) to find the correct position: indicator (H fig. 9.33-2) indicates the adjusting measure.
-
When the adjustment has been carried out, tighten the knob (C fig. 9.33-2).
For micrometric adjustment of fence half (B fig. 9.33-2):
-
slacken the knob (G fig. 9.33-2).
-
Turn knob (E fig. 9.33-2) and with a bar check the alignment of the fence half with the tool.
-
When the adjustment has been carried out, tighten the knob (G fig. 9.33-2).
NOTE-INFORMATION:
Read the deviation between the two tables on index (H fig. 9.33-2). When the index is positioned on
"0", the fences are aligned.
