EN
4 - INSTALLATION
THIS MANUAL IS PROPERTY OF SCM INDUSTRIA S.P.A - ANY TOTAL OR PARTIAL REPRODUCTION IS STRICTLY FORBIDDEN
Cap.
4
Pag.
27/53
4.3.43
FITTING - DADO SET
(mmax_4.3.43_0.0)
ONLY FOR U.S.A. and CANADA VERSION
DANGER-WARNING:
“DADO SET” blades.
This machining cannot be carried out with a tilted saw blade. The piece must be moved forward
using a wood pusher.
Blades with a diameter of more than 8" (203,2 m) must not be mounted; the combination of blades
used must not exceed a thickness of 3/4" (19 mm).
Exclude the engraver by lowering it under the saw table.
DANGER-WARNING:
- use proper gloves for handling the saw blade.
- In case of large pieces and it is necessary the help of another person, on the machine, we
recommend to apply an extension table to the exit side for removing the piece already cut and the
second operator shall stay at the exit side of the additional table.
DANGER-WARNING:
before carrying out any of the operations make sure to cut the main electric power and disconnect
socket T from plug S.
U.S.A. and CANADA version:before carrying out maintenance operations, adjustments or to
dismount any machine member turn main switch (F fig. 4.3-43) to 0, lock it then indicate this with a
sign.
DANGER-WARNING:
WAIT UNTIL THE SAW BLADES ARE STILL.
For fitting or replacing the saw blade proceed as follows:
1)
lift the saw unit totally up (inclination: 90°).
2)
Position the squaring frame (A fig.4.3-43) as shown in the figure and translate the wagon (H fig.4.3-43)
completely to the right.
3)
Lower the lever (M fig.4.3-43) and open the guard (N fig.4.3-43).
4)
Fit pin (B fig.4.3-43) into the saw shaft pulley hole.
NOTE-INFORMATION:
(U.S.A. and CANADA version) a limit switch ensures that with guard (N fig. 4.3-43) open the motor
can not be started.
NOTE-INFORMATION:
the locking nut (C fig. 4.3-43) of the saw blade is counter-clockwise; to unscrew it turn it clockwise.
