4 - INSTALLATION
EN
Pag.
22/53
- Cap.
4
THIS MANUAL IS PROPERTY OF SCM INDUSTRIA S.P.A - ANY TOTAL OR PARTIAL REPRODUCTION IS STRICTLY FORBIDDEN
4.3.36
FITTING SCORER ASSEMBLY
(mmax_4.3.36-0.0)
DANGER-WARNING:
before carrying out any of the operations make sure to cut the main electric power and disconnect
socket T from plug S.
U.S.A. and CANADA version:before carrying out maintenance operations, adjustments or to
dismount any machine member turn main switch (Y fig. 4.3-36A) to 0, lock it then indicate this with
a sign.
•
Remove the saw blade as shown in Chap. 4.
•
Disassemble the front guard (Z fig. 4.3-36A).
•
Completely lower the saw assembly and incline it by 45° (see Chapter 6).
•
Fit the unit (A fig. 4.3-36A).
•
Tighten the nut (D fig. 4.3-36A) to lock the scoring saw unit (A fig. 4.3-36A).
•
Remove the part (E fig. 4.3-36A) and the plate (S fig. 4.3-36A)
•
Fit the lift knob (1 fig. 4.3-36A) and the transfer knob (2 fig. 4.3-36A).
•
Fit the spring (N fig. 4.3-36A) on the scoring saw unit .
•
Install the pulley (P fig. 4.3-36A) on the saw arm.
•
Install the pulley (Q fig. 4.3-36A) in the saw shaft.
•
Fit the bracket-pulley unit (belt tightener) (G fig. 4.3-36A), on the saw arm, securing it with the screw (V fig.
4.3-36A) but not actually locking it.
Check that pulleys (P fig. 4.3-36A) and (R fig. 4.3-36A) are perfectly in line with pulley (Q fig. 4.3-36A) and if
necessary place spacers between them.
•
Fit the scoring saw tensioning spring (X fig. 4.3-36A) hook up screw (M fig. 4.3-36A).
•
Fit belt (H fig. 4.3-36A) positioning it along the route shown in the figure.
•
Fit the saw blade and the scorer, as shown in Chap. 4.
•
Fit the front guard (Z fig. 4.3-36A).
•
Fit the new plate (W fig. 4.3-36A) and reposition the part (E fig. 4.3-36A).
NOTE-INFORMATION:
Fit the lift knob (1 fig. 4.3-36A) and adjust it using the nuts (B, C fig. 4.3-36A) as indicated below:
Screw on the knob (1 fig. 4.3-36A), raise the scoring saw blade until it projects over the work table
by 3 mm. Move the nut (B fig. 4.3-36A) up to the stop on the saw bracket and then lock it in place
with the nut and washer (C fig. 4.3-36A).
Fit the transfer knob (2 fig. 4.3-36A) and lock it in place with the nut (F fig. 4.3-36A).
NOTE-INFORMATION:
belt is assured by the spring (X fig. 4.3.36A) and it does not require any adjustment.
