7 - SUPPORTING FRAME AND FENCE FOR PARALLEL CUTS: USE AND
ADJUSTMENT
EN
Pag.
6/26
- Cap.
7
THIS MANUAL IS PROPERTY OF SCM INDUSTRIA S.P.A - ANY TOTAL OR PARTIAL REPRODUCTION IS STRICTLY FORBIDDEN
7.14.2
OPERATION
(gu_7-14-2_0.0)
It is used for parallel cuts with cutting width up to 815 mm (CU 300), 900 mm (CU 410).
Standard saw fence
Rule (R fig. 7.14-2) can move in longitudinal direction after unlocking the nuts (P fig. 7.14-2); after every adjustment
tighten nuts (P fig. 7.14-2).
The parallel rule shall be adjusted in longitudinal direction, so that the workpiece can not lock between rule and
riving knife.
DANGER-WARNING:
the front end of the line must never protrude from the floor at the end (F fig. 7.14.2), but must arrive
at an imaginary line (G fig. 7.14.2) that starts from the first tooth of the blade and slide forward to
45°. This is to prevent the ascent saw teeth to grab the piece and cast against the operator.
Positions of rule (R fig. 7.14-2) after loosening the nuts (P fig. 7.14-2).
1)
Vertical position with side (W fig. 7.14-2) turned to the workpiece.
2)
Horizontal position (O fig. 7.14-2) for cutting thin pieces and slanting cuts.
DANGER-WARNING:
it is possible to move the piece forwards by using pusher (H fig. 7.14-2) supplied with the machine.
3)
After carrying out every adjusting operation tighten the nuts (P fig. 7.14-2).
To increase or decrease the distance between the fence and the saw blade operate as indicated below.
-
Loosen handle (D fig. 7.14-2);
-
manually slide the fence unit with reference to the metric ruler (E fig. 7.14-2);
-
block handle (D fig. 7.14-2).
As soon as the adjustment has been carried out, bring the fence lock (T fig. 7.14-2) to the stop on the surface unit
fence (R fig. 7.14-2) and tighten knob (U fig. 7.14-2).
DANGER-WARNING:
before starting machining, make sure that the guard is resting on the workpiece.
NOTE-INFORMATION:
to obtain the maximum cutting width at the saw guide, set up the machine proceeding as follows:
-
remove fence (R fig. 7.14-2) together with relative bracket.
-
Remove bracket (B fig. 7.14-2).
-
Release the lever (L fig. 7.14-2) and turn over the protection (Q fig. 7.14-2) by 180°.
-
Reinstall bracket (B fig. 7.14-2).
-
Reinstall fence (R fig. 7.14-2) together with relative bracket.
-
position guide (R fig. 7.14-2) on the extension (M fig. 7.14-2).
As soon as the adjustment has been carried out, bring the fence lock (1 fig. 7.14-2) to the stop on the surface unit
fence (R fig. 7.14-2) and tighten knob (2 fig. 7.14-2).
