9a - OPERATIONS AND ADJUSTMENTS OF SPINDLE
EN
Pag.
38/45
- Cap.
9a
THIS MANUAL IS PROPERTY OF SCM INDUSTRIA S.P.A - ANY TOTAL OR PARTIAL REPRODUCTION IS STRICTLY FORBIDDEN
9A.50.1
ADJUSTING
(cu_9a-50-1_0.0)
Before working adjust the pressure exerted by vertical and horizontal pressure shoes.
The workpiece shall easly move without shocks between pressure shoes and fence halves, therefore the pressure
shall be not too strong.
-
Adjust fence halves (A e B fig. 9.50-1) according to the external cutter diameter.
Adjust the position of the horizontal presser (1 fig. 9.50-1) and the vertical presser (2 fig. 9.50-1) resting it on the
piece to be machined and proceed as follows:
-
slacken the handle (G fig. 9.50-1) and transversally adjust the presser belt (1 fig. 9.50-1) on the basis of the
width of the wood to be processed.
-
When the adjustment has been carried out, tighten the handle.
-
Loosen the knobs (L fig. 9.50-1) and (M fig. 9.50-1) and position the vertical presser (2 fig. 9.50-1) on the
wood maintaining it is close as possible to the cutter.
-
Lock the knobs (L fig. 9.50-1) and (M fig. 9.50-1) when the adjustment has been completed.
Adjust the pressure shoes in order to protect the operator against eventual ejection of splits or tool
parts.
NOTE-INFORMATION:
after every adjustment make sure that the knobs are tight.
DANGER-WARNING:
use flat pusher (9 fig. 9.50-1) to make the piece passage under horizontal pressure shoe (1 fig. 9.50-
1) easier.
NOTE-INFORMATION:
the min. section of the workpiece which may be pressed is 8x8 mm on the entire length.
CAUTION:
turn the tool after carrying out all adjustments in order to avoid any contact with machine parts or
with the guard.
