7a - SURFACER USE AND ADJUSTING
EN
Pag.
4/15
- Cap.
7a
THIS MANUAL IS PROPERTY OF SCM INDUSTRIA S.P.A - ANY TOTAL OR PARTIAL REPRODUCTION IS STRICTLY FORBIDDEN
If the knives are well adjusted, the finished workpieces are not convex without the step at their rear end.
NOTE-INFORMATION:
to achieve a quality finish the THICKNESSER MUST BE PERFORMED immediately after the
SURFACE PLANER.
To wear the knives uniformly, and thus improve the quality of the work and reduce the
maintenance times and costs, it is GOOD PRACTICE to use the knives along the whole length of
the cut!
If planing a narrow workpiece, feeding it on the external side (1) of the planer, in the subsequent
thicknessing the workpiece must be positioned in order to use the section of knives (2) that was
not used in the previous operation.
When working large workpieces it is always GOOD PRACTICE to position the centre line of the
workpiece on the centre line of the planer!
IMPORTANT
Keep the knives and gibs always clean to ensure the best performance of the machine.
Remove resin residues, sawings and chips with a hard bristle brush and terpentine, kerosene or light oil.
Never use other different product or synthetic solvents.
Remove dirty then dry each part.
Clean the worktable with a dry cloth.
