9 - THICKNESSING USE AND ADJUSTING
EN
Pag.
10/12
- Cap.
9
THIS MANUAL IS PROPERTY OF SCM INDUSTRIA S.P.A - ANY TOTAL OR PARTIAL REPRODUCTION IS STRICTLY FORBIDDEN
9.9
SAFETY
GUARDS
(fs_9-9_0.0)
-
Anti-kickback fingers (T fig. 9.9) working with pieces of different thickness prevent the workpiece to be
thrown back towards the operator, thus providing an effective protection.
-
Before starting the working check that the fingers (T fig. 9.9) can rotate smoothly around their support shafts.
-
The presence of chips and dust in position corresponding to anti-kickback fingers (T fig. 9.9) can
compromise the good machine operation.
-
The opening of anti-kickback fingers (T fig. 9.9) can cause the ejection of splints compromising the operator
safety.
-
To prevent binding or jamming of some fingers (T fig. 9.9), always keep clean them clean by removing the
shavings fitted in the fingers.
-
Remove resin residues by washing the unit with a brush and terpentine.
NEVER OIL OR GREASE THE ANTI-KICK BACK FINGERS.
Thicknessing can only be carried out if the safety guard is in position (A fig. 9.9).
FORBIDDEN:
the machine use is forbidden if these conditions are not ensured.
SAFETY WARNINGS
-
Periodically press emergency button to verify the efficiency.
-
DO NOT process wood pieces with clefts, knots etc.
-
DO NOT feed boards with different thickness at the same time.
-
Make sure that the feed rollers are free to rise in the right way.
-
Never stay in front of the machine infeed side during the working and do not try to look inside the machine;
there is the danger that the splinters are ejected.
-
Never put your hands inside the machine to remove chips or splinters when the machine is running.
-
When a workpiece is locked in the machine, stop the cutterblock, lower the table, take off the piece.
-
DO NOT try to carry out depth of cut larger than the one specified.
-
It is forbidden to move the table when the machine is running.
-
DO NOT workpieces of too large thickness or lower than 3.0 mm
-
DO NOT workpieces of length lower than 120 mm
