20 - MAINTENANCE
EN
Pag.
6/44
- Cap.
20
THIS MANUAL IS PROPERTY OF SCM INDUSTRIA S.P.A - ANY TOTAL OR PARTIAL REPRODUCTION IS STRICTLY FORBIDDEN
Rules for a correct machine cleaning
SURFACE PLANING AND THICKNESSING MACHINE
Every evening by using a proper aspirator clean:
-
the table, cutterblock, anti kickback fingers and the cavities where you see dust and chips seepage;
-
periodically clean the rollers by using not dangerous products; never use acid products;
-
suction hoods (C fig.20.1) by checking that there are no occlusions.
Never use acid products.
After sucking chips or dust, with a cloth drunken with a not dangerous solvent clean:
-
all moving parts, particularly the ones exposed to the resin and to the dust;
-
knives (B fig. 20.1C) of the cutterblock;
-
sliding rod (D fig. 20.1C) of planer guide
;
-
guides (E fig. 20.1C) for mortiser sliding
;
-
sliding rods (P fig. 20.1C) of mortising table
;
-
screw (V fig. 20.1C) for
mortiser height adjusting;
-
thicknessing table - Screw (S fig. 20.2) for height adjusting;
-
thicknessing table - Sliding cylinder (Z fig. 20.1C).
FORBIDDEN:
NEVER OIL OR GREASE THE ANTI-KICK BACK FINGERS.
