7 - SUPPORTING FRAME AND FENCE FOR PARALLEL CUTS: USE AND
ADJUSTMENT
EN
Pag.
12/26
- Cap.
7
THIS MANUAL IS PROPERTY OF SCM INDUSTRIA S.P.A - ANY TOTAL OR PARTIAL REPRODUCTION IS STRICTLY FORBIDDEN
7.23
USE OF SLIDING TABLE AND FRAME FOR LARGE
PANELS
(ev_7-23_0.0)
7.23.1
ALUMINIUM SLIDING TABLE
(ev_7-23-1_0.0)
The aluminium sliding table moves on high precision slideways made of hardened steel in order to ensure the
uniform and smooth motion with small friction, necessary for obtaining precise cuts.
The sliding table is locked and unlocked by means of lever (A fig. 7.23-1):
1)
lever up: sliding table locked.
2)
Lever down: sliding table unlocked.
The sliding table may be locked in 2 points:
-
the lever (A fig. 7.23-1) is used to lock the wagon in the rest position (wagon closed) and in the loading
position for the piece to be machined (wagon translated to right end stop).
Fasten the following devices:
-
fit gib of column (D fig. 7.23-1) into groove of sliding table, fit arm (E fig. 7.23-1) to the column, then tighten
handle (F fig. 7.23-1).
-
Fit tile-shaped stop (G fig. 7.23-1) by inserting the gib into the groove of sliding table, hen tighten handle (H
fig. 7.23-1).
-
Fit handle (L fig. 7.23-1, supplied in the accessories bag) to sliding table to the desired position then screw
down it.
The structure of device (G fig. 7.23-1) permits to perform precision stops also in pieces having an irregular stop
surface.
DANGER-WARNING:
to move the sliding table ALWAYS use handle (L fig. 7.23-1 ).
DANGER-WARNING:
move the sliding table only with handle (L fig. 7.23-1) to avoid the possible squashing of the hands
with the fixed part of the machine.
