7 - SUPPORTING FRAME AND FENCE FOR PARALLEL CUTS: USE AND
ADJUSTMENT
EN
Pag.
16/26
- Cap.
7
THIS MANUAL IS PROPERTY OF SCM INDUSTRIA S.P.A - ANY TOTAL OR PARTIAL REPRODUCTION IS STRICTLY FORBIDDEN
7.24
EXAMPLE: LONGITUDINAL CUT
(ev_7-24_0.0)
CAUTION:
when working with the saw completely close the router hole using the rings provided. After
finishing work, completely lower the saw protection resting on the table.
The choice of the method to use to make a cut with the circular saw depends on the dimensions of the wood to be
machined and the type of machining to be carried out.
For cutting ennobled wood, use of the engraver
is indispensable to prevent chipping.
When the engraver
is not needed, lower it completely underneath the table.
Adjust the saw and engraver
assembly as described in Chap. 6.
DANGER-WARNING:
always secure the workpiece by means of the presser when a sliding wagon is used.
Always use supports when machining panels having great dimensions.
7.24.1
FIRST
CUT
(ev_7-24-1_0.0)
When machining large panels, position the telescopic ruler and the squaring frame for thrust machining (see fig.
7.24-1); with this position maximum cutting length is obtained.
-
Move the sliding table to the end of stroke (see fig. 7.24-1), lock lever (B fig. 7.24-1).
-
Rest the panel on the sliding table and frame see fig. 7.24-1.
-
Loosen handle (F fig. 7.24-1) and move the tile-shaped stop (D fig. 7.24-1) into the groove and rest it against
the panel.
-
Clamp the handle (F fig. 7.24-1).
-
Move clamping device (E fig. 7.24-1) close to the panel.
-
Unlock the sliding table by means of lever (B fig. 7.24-1).
DANGER-WARNING:
move the panel against the saw blade (set at the right height) by moving the sliding table by means
of handle (C fig. 7.24-1).
When loading the piece onto the wagon, take care not to knock the saw blade.
