7 - SUPPORTING FRAME AND FENCE FOR PARALLEL CUTS: USE AND
ADJUSTMENT
EN
Pag.
8/26
- Cap.
7
THIS MANUAL IS PROPERTY OF SCM INDUSTRIA S.P.A - ANY TOTAL OR PARTIAL REPRODUCTION IS STRICTLY FORBIDDEN
Optional saw fence
Rule (R fig. 7.14-2bis) can move in longitudinal direction after unlocking handles (P fig. 7.14-2bis); fter every
adjustment tighten handles.
The parallel rule shall be adjusted in longitudinal direction, so that the workpiece can not lock between rule and
riving knife.
DANGER-WARNING:
the front end of the line must never protrude from the floor at the end (F fig. 7.14.2bis), but must
arrive at an imaginary line (G fig. 7.14.2bis) that starts from the first tooth of the blade and slide
forward to 45°. This is to prevent the ascent saw teeth to grab the piece and cast against the
operator.
Positions of rule (R fig. 7.14-2bis) after loosening handles (P fig. 7.14-2bis).
1)
Vertical position with side (W fig. 7.14-2bis) turned to the workpiece.
2)
Horizontal position (O fig. 7.14-2bis) for cutting thin pieces and slanting cuts.
DANGER-WARNING:
it is possible to move the piece forwards by using pusher (H fig. 7.14-2bis) supplied with the
machine.
3)
After carrying out every adjusting operation tighten handles (P fig. 7.14-2bis).
To increase or decrease the distance between the fence and the saw blade operate as indicated below.
-
Release the lever (X fig. 7.14-2bis) and the knob (S fig. 7.14-2bis);
-
manually slide the fence unit (Q fig. 7.14-2bis) with reference to the metric ruler (E fig. 7.14-2bis).
Carry out the micrometric adjustment proceeding as follows:
-
lock the knob (S fig. 7.14-2bis);
-
operate the knob (Y fig. 7.14-2bis) to adjust the fence micrometrically;
-
tighten the lever (X fig. 7.14-2bis) when the adjustment has been made.
As soon as the adjustment has been carried out, bring the fence lock (T fig. 7.14-2bis) to the stop on the surface
unit fence (R fig. 7.14-2bis) and tighten knob (U fig. 7.14-2bis).
DANGER-WARNING:
before starting machining, make sure that the guard is resting on the workpiece.
NOTE-INFORMATION:
to obtain the maximum cutting width at the saw guide, set up the machine proceeding as follows:
-
remove fence (R fig. 7.14-2bis) together with relative bracket.
-
Remove bracket (B fig. 7.14-2bis).
-
Release the lever (L fig. 7.14-2bis) and turn over the protection (Z fig. 7.14-2bis) by 180°.
-
Reinstall bracket (B fig. 7.14-2bis).
-
Reinstall fence (R fig. 7.14-2bis) together with relative bracket.
-
position guide (R fig. 7.14-2bis) on the extension (M fig. 7.14-2bis).
As soon as the adjustment has been carried out, bring the fence lock (1 fig. 7.14-2bis) to the stop on the surface
unit fence (R fig. 7.14-2bis) and tighten knob (2 fig. 7.14-2bis).
