9a - OPERATIONS AND ADJUSTMENTS OF SPINDLE
EN
Pag.
44/45
- Cap.
9a
THIS MANUAL IS PROPERTY OF SCM INDUSTRIA S.P.A - ANY TOTAL OR PARTIAL REPRODUCTION IS STRICTLY FORBIDDEN
9A.55.3
WORKING
EXAMPLES
(cu_9a-55-3_0.0)
This operation is carried out for obtaining profiles along bent lines. The shaping is carried out by means of the
milling cutter (A fig. 9.55-3) and the copying ring (D fig. 9.55-3) fitted on the hood (C fig. 9.55-3).
CAUTION:
adjust the hood as indicated in paragraph 9A.55-2.
Before starting work check the various fittings and turn the tool manually to prevent possible
contact with fixed parts.
Connect fitting (4 fig. 9.55-3) to the suction system.
For machining proceed by placing the profile on the guide (E fig. 9.55-3), firmly fixed to the support and push it up
to the reference (H fig. 9.55-3) stamped on the rest.
Thus progressive attachment is obtained until maximum cutting depth.
The reference (H fig. 9.55-3) indicates the point of maximum cutting depth.
NOTE-INFORMATION:
to obtain regular removal the whole machining process must be carried out in correspondence to
the reference (H fig. 9.55-3).
As a material for the template (P fig. 9.55-3) use a multilayer panel; the template shall be equipped
with clamps (S fig. 9.55-3).
DANGER-WARNING:
set the clenched fists flat on the piece and push it forward by resting it against fence (E fig. 9.55-3)
or against the straight part of the steady rest.
In case of milling against the wood grain or in tranverse direction to the wood grain (dangerous
situation), you have to reduce the feed motion to avoid the wood fiber rupture.
