5 - CONTROLS
EN
Pag.
6/14
- Cap.
5
THIS MANUAL IS PROPERTY OF SCM INDUSTRIA S.P.A - ANY TOTAL OR PARTIAL REPRODUCTION IS STRICTLY FORBIDDEN
5.4.1
PROFILING
OPERATIONS
(cu_5-4-1_0.0)
Make sure that:
-
hood-fence unit (V fig. 5.4-1) is in right position and locked by knobs (H, B fig. 5.4-1).
-
NEVER exceed the max speed nMAX indicated on the tool; see Chapter 9A.
-
Presser shoes (F and G fig. 5.4-1) cover the toolas much as possible (see paragraph 9.50A); for the
workpiece feed use a proper pusher (S fig. 5.4-1) or a feeder.
5.4.2
MILLING AT THE SPINDLE (SHAPING)
(cu_5-4-2_0.0)
Check that:
-
guard (P fig. 5.4-1) is in the right position (with the pin inserted in the slot on the table) and locked by the pin
(M fig. 5.4-1).
-
The speed is proper for the tool (see Chapter 9A).
5.4.3
TENONING
(cu_5-4-3_0.0)
Check that:
-
tenoning hood (T fig. 5.4-1) is in right position and locked by knobs (R fig. 5.4-1).
-
The max. spindle speed is 3500 (4200 - 60 Hz) rpm and that it does not exceed the max. speed permitted for
the fitted tool.
