4 - INSTALLATION
EN
Pag.
40/53
- Cap.
4
THIS MANUAL IS PROPERTY OF SCM INDUSTRIA S.P.A - ANY TOTAL OR PARTIAL REPRODUCTION IS STRICTLY FORBIDDEN
4.3.76
FITTING
SPINDLE
(cu_4-3-76_0.0)
DANGER-WARNING:
all adjusting operations are to be carried out with standstill spindle.
4.3.76.1
INTERCHANGEABLE
SPINDLE
(cu_4-3-76-1-0.0)
DANGER-WARNING:
take off or fit the interchangeable spindle when no tools are fitted to the spindle.
Handle the tools with protective gloves.
Before carrying out any of the operations make sure to cut the main electric power and disconnect
socket (T fig. 4.3-76-1) from plug (S fig. 4.3-76-1).
(U.S.A. and CANADA version): main switch (2 fig. 4.3-76-1) is turned to I (ON).
1)
(U.S.A. and CANADA version) Turn the selector (G fig. 4.3-76-1) to the symbol ( ).
2)
Release the moulder motor brake by turning selector (W fig. 4.3-76-1) to position "I".
3)
Release the knob (A fig. 4.3-76-1).
4)
Lift the spindle shaft up to its maximum height by turning the handwheel (B fig.4.3.82.1).
5)
Lift the lever (M fig. 4.3-76-1);
(U.S.A. and CANADA version: which acts on a microswitch that stops the motor starting up).
6)
Open the door (V fig.4.3.76.1).
7)
Lock rotation of the router spindle turning it manually until managing to lock it with the accessory pin (C
fig.4.3.76.1)
8)
Unscrew ring nut (Q fig. 4.3.76.1) counterclockwise by wrench (P fig.4.3.76.1) in order to take off spindle (O
fig. 4.3.76.1).
9)
Make sure that taper shanks (D fig. 4.3.76.1) and the threads of the spindle and of the chuck are clean, free
from dents and flat.
10) Fit the new spindle by screwing it down to the rubber ring (R fig. 4.3.76.1), clamp it by half turn, then tighten
ring nut (Q fig. 4.3.76.1) by turning wrench (P fig. 4.3.76.1) clockwise.
Unlock the rotation of the moulder shaft by removing the pin (C fig. 4.3.76.1).
Close the door (V fig. 4.3.76.1).
Lower the lever (M fig. 4.3.76.1).
DANGER-WARNING:
after machining, before changing the spindle, allow it to cool, then substitute it.
The right machine use is a determinant factor to obtain the best results. It is important to carry out
the maintenance operations foreseen in this handbook.
DANGER-WARNING:
in order to allow the interchangeable toupie shaft to come down completely below the worktop, it is
NECESSARY to remove the spacer rings (E fig. 4.3.76.1), after having removed the screw (N fig.
4.3.76.1) which stops them, as described in Par. 4.3.82.1.
