6 - SAW UNIT USE AND ADJUSTMENT
EN
Pag.
8/11
- Cap.
6
THIS MANUAL IS PROPERTY OF SCM INDUSTRIA S.P.A - ANY TOTAL OR PARTIAL REPRODUCTION IS STRICTLY FORBIDDEN
6.7
GROOVES WITH SAW BLADE
(six_6-7_0.0)
DANGER-WARNING:
maximum work piece thickness: h = 40 mm
maximum groove depth: S = h/2 mm
FORBIDDEN:
IT IS FORBIDDEN to cut a groove only on a partial section of the panel.
The machining must be performed on the entire length of the panel.
IT IS FORBIDDEN to disassemble the divider knife.
DANGER-WARNING:
The machine has been designed to use only tools for manual feed (marked MAN), in accordance
with EN 847-1 Norm, proper for the material used.
DANGER-WARNING:
When working with small pieces, work the piece by making use of a wood pusher.
Exclude the scoring saw by lowering it below the saw plane.
FORBIDDEN:
It is forbidden to perform this task with the inclined saw blade.
To make a groove with a saw blade, proceed as follows:
DANGER-WARNING:
stop the machine to carry out adjustments or to demount any machine, turn the main switch to
zero and lock it, then indicate it by a sign.
The operator who carries out the machine set up, maintenance and cleaning shall keep the only
key.
-
Remove the guard P from the riving knife (see Par. 6.7);
-
adjust riving knife (F fig. 6.7) height by unloosing nut (G fig. 6.7).
-
prepare a protection (B fig. 6.7, not supplied by the manufacturer) made with "machinable material e.g. light
alloys, plywood, polyamide, polypropylene, or other plastic material with similar specifications), and with the
dimensions indicated.
DANGER-WARNING:
the protection B must be wide enough to prevent access to the blade.
If "L" is the machining quota, the width of the protection must be:
Lp = L + 50 mm (Lp min. = 200 mm)
