4 - INSTALLATION
EN
Pag.
18/53
- Cap.
4
THIS MANUAL IS PROPERTY OF SCM INDUSTRIA S.P.A - ANY TOTAL OR PARTIAL REPRODUCTION IS STRICTLY FORBIDDEN
4.3.30.1 FITTING THE ANGLED CUTS DEVICE
(mmax_4.3.30.1_0.0)
1)
Insert the stud bolt (N fig. 4.3-30-1) with the presser (E fig. 4.3-30-1) into the groove of the wagon (C fig. 4.3-
30-1).
2)
Mount the ruler assembly (A fig. 4.3-30-1) inserting the gib (R fig. 4.3-30-1) in the groove of the wagon (C fig.
4.3-30-1).
3)
Tighten the lever (G fig. 4.3-30-1).
4)
Loosen handle (F fig. 4.3-30-1).
5)
Position the ruler assembly at the right distance from the saw blade; at a 90° angle send the ruler assembly
to stop up against the gib (L fig. 4.3-30-1); the gib (L fig. 4.3-30-1) is adjusted by our technicians and serves
to quickly position the ruler assembly at the right distance from the saw blade.
6)
To make angular cuts turn the ruler assembly (A fig. 4.3-30-1) using index (D fig. 4.3-30-1) as a reference.
7)
Block by tightening handle (F fig. 4.3-30-1).
8)
Position the presser up against the ruler assembly ensuring that the washer (Q fig. 4.3-30-1) is inserted into
the groove.
9)
Rotate the stud bolt (N fig. 4.3-30-1) clockwise to block.
The table has already been adjusted; to adjust proceed as follows:
-
loosen levers (G fig. 4.3-30-1);
-
adjust the dowels (S fig. 4.3-30-1) to ensure the table is parallel to the wagon;
-
loosen screws (T fig. 4.3-30-1) and move the dowels (U fig. 4.3-30-1) to adjust the height position.
When the clip guard (M fig. 4.3-30-1) is worn, bring it up against the saw blade by turning the blocking screws.
Fig. 4.3-30-1
