7a - SURFACER USE AND ADJUSTING
EN
Pag.
8/15
- Cap.
7a
THIS MANUAL IS PROPERTY OF SCM INDUSTRIA S.P.A - ANY TOTAL OR PARTIAL REPRODUCTION IS STRICTLY FORBIDDEN
7A.5
HELICOIDAL PLANER - TIPS REPLACEMENT
(fs_7-5_0.0)
DANGER-WARNING:
all adjusting operations are to be carried out with standstill spindle.
DANGER-WARNING:
before carrying out any of the operations make sure to cut the main electric power and disconnect
socket T from plug S.
U.S.A. and CANADA version:before carrying out maintenance operations, adjustments or to
dismount any machine member turn main switch (Y fig. 7.5) to 0, lock it then indicate this with a
sign.
DANGER-WARNING
to handle the knives and the cutterblock you shall wear safety gloves.
For correct routine maintenance and cleaning, reach the planer unit and carry out the operations described below.
DANGER-WARNING
remove the planing fence unit (A fig.7.5) from the table.
-
Slacken the levers (R, T fig. 7.5) as shown in figure.
Llift the planing tables (E, D fig. 7.5) by using the handles (G fig. 7.5);
(the opening of the tables activates a microswitch that stops the machine from switching on USA
and CANADA).
CAUTION:
check that the block (N fig. 7.5) of the table opening is correctly positioned.
-
Rotate the planer (F fig. 7.5) to move the tip being replaced in a more accessible position.
Loosen securing screw (V fig. 7.5) and extract tip-tool (U fig. 7.5).
Clean rest surface (C fig. 7.5) to prevent any dust from being accumulated.
Insert again the used tip-tool after you have rotated itself of 90 degrees as to its initial position or insert a
new one.
Insert the securing screw (V fig. 7.5) and use a dynomometric key (Z fig. 7.5) to tighten it.
-
Disengage the block (N fig. 7.5) and close the tables.
Lower the surfacing tables (E, D fig. 7.5). Turn and push the lever (T fig. 7.5) to lock table (E fig. 7.5).
Turn and push the lever (R fig. 7.5) to lock table (D fig. 7.5).
-
Place the machine accessories according to the working to be carried out.
DANGER-WARNING
the tightening torque must be: 5,7 N • m
Each tip-tool has 4 cutting edges; after you have utilized all its cutting edges, the tip-tool must be
replaced. Do not utilize tip-tools reground.
