7a - SURFACER USE AND ADJUSTING
EN
Pag.
14/15
- Cap.
7a
THIS MANUAL IS PROPERTY OF SCM INDUSTRIA S.P.A - ANY TOTAL OR PARTIAL REPRODUCTION IS STRICTLY FORBIDDEN
7A.9
FENCE
(lab_7a-9_0.0)
DANGER-WARNING
during the machining, the protections (F fig. 7.9) and (L fig. 7.9) must always be positioned on the
cutterblock.
-
Position the planing fence (B fig. 7.9) at the desired point and tighten the knob (S fig. 7.9).
-
To angle the fence from 90° to 45° loosen the locking device (C fig. 7.9) and adjust the fence, observing the
value on the index (T fig. 7.9).
-
As soon as the adjustment has been carried out, bring the fence lock (P fig. 7.9) to the stop on the surface
unit fence (B fig. 7.9) and tighten knob (R fig. 7.9).
NOTE-INFORMATION:
fence (B fig. 7.9)may be tilted from 90° to 45° and in any intermediate position.
For eventual corrections of the stops for extreme positions (90° and 45°) operate on screw and counternut (D fig.
7.9) for 90° position and on screw and counternut (H fig. 7.9) for 45° tilting.
NOTE-INFORMATION:
check perfect cleanage of the sliding rod (E fig. 7.9).
CAUTION:
lifting and handling the guide should only be carried out by personnel specially trained to execute
this kind of operations, to prevent accidents or to prevent guide from being damaged.
DANGER-WARNING:
machining thin pieces.
To machine thin pieces use an auxiliary guide (not supplied by the
SCM
). In par. 10.3.1.10 there is
the information for the construction and installation.
