Frequently Asked Questions
What are the different parts of the LiftMeUp?
A- Backrest (moving part with the wooden
slats)
B- Base (always in contact with the bed)
C- Handle bar (always use to carry or move
the LiftMeUp)
D- Power box
E- Power cable (to plug in the wall)
F- Hand control (always use to operate the
LiftMeUp)
A profiled foam topper, a fitted sheet and a safety strap are also included with the LiftMeUp.
How do I install the LiftMeUp at the head of the bed?
No assembly or tool required!
3 easy steps:
1- Place the LiftMeUp on the mattress of your bed with the wooden slats facing up. The
LiftMeUp can be installed on any size bed and on either side of a queen or king size bed.
Make sure that the whole width of the base and the handle bar are entirely in contact with
the mattress. Check that the wires are not pinched under the base or constricted in any way
Push the LiftMeUp against the headboard of the bed or against a wall. ALWAYS install the
LiftMeUp against a support so it does not slip when the backrest gets raised. ALWAYS use
the strap provided to securely fasten the base of the LiftMeUp to the bed mattress. When
the backrest gets raised, the recliner will slip if not properly secured against a support.
2- Cover the foam topper with the fitted sheet and position it on the backrest with its thicker
side aligned with the top of the frame.
3- Plug the cable into the wall plug. Make sure the wire is out of the way and does not
constitute a tripping hazard. On the hand control, press the 'UP' button for about 5 seconds
to raise the backrest then let go. This is to test that all connections are working properly. This
also allows you to stretch the fitted sheet over the back plate of the backrest to secure the
mattress in place. Use the hook to position the handset at a place easy to reach by the user.
Your LiftMeUp is now ready to use!
For detailed steps and pictures, please refer to the User’s Manual by using the link provided at
the bottom of the Page “Our Products” on our website.
