Rohde & Schwarz FSV3000, Руководство пользователя

Страница: 959 / 1489

Remote commands
R&S
®
FSVA3000/ R&S
®
FSV3000
959 User Manual 1178.8520.02 ─ 08
CALCulate<n>:ESPectrum:PSEarch:PSHow <State>
CALCulate<n>:ESPectrum:PEAKsearch:PSHow <State>
This command turns the peak labels in the diagram on and off.
Peak labels are blue squares.
Suffix:
<n>
.
Window
Parameters:
<State> ON | OFF | 1 | 0
*RST:
0
Example: CALC:ESP:PSE:PSH ON
Marks all peaks with blue squares.
Manual operation: See "Show Peaks" on page 256
12.5.6.9 Performing an SEM measurement
The following commands are required to perform an SEM measurement:
●
SENS:SWE:MODE ESP
, see
[SENSe:]SWEep:MODE
on page 929
●
INITiate<n>[:IMMediate]
on page 861
12.5.6.10 Retrieving results
The following commands analyze and retrieve measurement results for SEM measure-
ments.
●
CALCulate<n>:LIMit<li>:FAIL?
on page 1246
●
TRACe<n>[:DATA]
on page 1162
●
TRACe<n>[:DATA]:MEMory?
on page 1162
●
TRACe<n>[:DATA]:X?
on page 1163
●
CALCulate<n>:MARKer<m>:FUNCtion:POWer<sb>:RESult?
on page 862
12.5.6.11 Example: SEM measurement
In this example we will configure and perform an SEM measurement. Note that this
example is primarily meant to demonstrate the remote control commands, it does not
necessarily reflect a useful measurement task. For most common measurement stand-
ards, the R&S
FSV/A performs the measurement optimally with the predefined set-
tings, without further configuration.
//-----------Preparing the measurement ------------
//Reset the instrument
*RST
//------------ Preparing the measurement------------
//Activate SEM Measurement
Configuring and performing measurements