R&S SMJ100A, Руководство по эксплуатации

Страница: 606 / 874

Remote Control Commands
R&S
®
SMJ100A
590 Operating Manual 1403.7458.32 ─ 14
Parameters:
<Inhibit> integer
Range:
0 to 67108863
*RST: 0
Default unit: sample
Example: BB:ARB:TRIG:SOUR EXT
selects an external trigger
BB:ARB:TRIG:INH 200
sets a restart inhibit for 200 samples following a trigger event.
Manual operation: See "Trigger Inhibit" on page 382
[:SOURce<hw>]:BB:ARBitrary[:TRIGger]:SEQuence <Sequence>
The command selects the trigger mode.
Parameters:
<Sequence> AUTO | RETRigger | AAUTo | ARETrigger | SINGle
AUTO
The waveform is output continuously.
RETRigger
The waveform is output continuously. A trigger event (internal or
external) causes a restart.
AAUTo
The waveform is output only when a trigger event occurs. After
the trigger event the waveform is output continuously. Waveform
output is stopped with command
SOUR:BB:ARB:TRIG:ARM:EXEC
and started again when a trig-
ger event occurs.
ARETrigger
The waveform is output only when a trigger event occurs. The
device automatically toggles to RETRIG mode. Every subse-
quent trigger event causes a restart. Waveform output is stop-
ped with command
SOUR:BB:ARB:TRIG:ARM:EXEC
and star-
ted again when a trigger event occurs.
SINGle
The waveform is output only when a trigger event occurs. After
the trigger event the waveform is output once to the set
sequence length (
SOUR:BB:ARB:TRIG:SLEN
). Every subse-
quent trigger event causes a restart.
*RST:
RETRigger
Example: BB:ARB:SEQ AAUT
sets the "Armed_auto" trigger mode; the device waits for the first
trigger (e.g. with
*TRG
) and then generates the signal continu-
ously.
Manual operation: See "Trigger Mode" on page 379
SOURce Subsystem