R&S SMJ100A, Руководство по эксплуатации

Страница: 608 / 874

Remote Control Commands
R&S
®
SMJ100A
592 Operating Manual 1403.7458.32 ─ 14
Parameters:
<OnTime> integer
Range:
1 to 14913079
*RST: 1
Example: BB:ARB:TRIG:OUTP2:ONT 20
sets an ON time of 20 samples for marker 2
Manual operation: See "Marker Mode" on page 388
[:SOURce<hw>]:BB:ARBitrary:TRIGger:OUTPut<ch>:PATTern <Pattern>
The command defines the bit pattern used to generate the marker signal in the setting
SOURce:BB:ARB:TRIGger:OUTPut:MODE PATTern
0 is marker off, 1 is marker on.
Parameters:
<Pattern> <32 bits pattern>
*RST:
0
Example: BB:ARB:TRIG:OUTP2:PATT #H39FE0000,32
sets a bit pattern.
BB:ARB:TRIG:OUTP2:MODE PATT
activates the marker signal according to a bit pattern on output
MARKER 2.
Manual operation: See "Marker Mode" on page 388
[:SOURce<hw>]:BB:ARBitrary:TRIGger:OUTPut<ch>:PULSe:DIVider <Divider>
The command sets the divider for the pulsed marker signal in the setting
SOURce:BB:ARB:TRIGger:OUTPut:MODE PULSe
. The pulse frequency is derived
by dividing the symbol rate by the divider.
Parameters:
<Divider> integer
Range:
2 to 1024
*RST: 2
Example: BB:ARB:TRIG:OUTP2:PULS:DIV 2
sets the divider for the marker signal on output MARKER 2 to
the value 2.
BB:ARB:TRIG:OUTP2:FREQ?
queries the resulting pulse frequency of the marker signal
Response: 66 000
the resulting pulse frequency is 66 kHz.
Manual operation: See "Marker Mode" on page 388
SOURce Subsystem