R&S SMJ100A, Руководство по эксплуатации

Страница: 413 / 874

Instrument Function
R&S
®
SMJ100A
397 Operating Manual 1403.7458.32 ─ 14
Figure 5-28: Example of marker signals
The segment begin is defined by the low-high slope of the marker. This applies for
switching between two segments as well as in case of segment replay.
●
General marker signals for the composed multi segment waveform
The "ARB" dialog provides also access to the standard marker settings. Settings
other than "unchanged" overwrite existing marker in the waveforms or markers
defined for the multi segment waveform.
The Figure 5-29 shows schematically how the instrument evaluates the priorities of the
different marker signals, if multiple marker signals are mapped to the same connector.
Figure 5-29: Marker priority used by assigning of marker signals to a hardware connector
Impact of the Trigger Settings and Next Segment Settings
The ARB dialog is equipped with the standard (regular) trigger settings. These settings
are provided for triggering of the composed multi segment waveform as a
sequence ,
i.e. as one file.
This section focuses on the additional settings provided for triggering of the individual
segments building the composed multi segment waveform. These settings are enabled
and visible only if a multi segment waveform is loaded for processing. The settings are
grouped in the "Multi Segment Waveform Options/Next Segment Trigger In" section.
The Figure 5-30 is intended to explain how trigger events impact the processing of the
multi segment waveforms.
Baseband Signal - Baseband Block