R&S SMJ100A, Руководство по эксплуатации

Страница: 659 / 874

Remote Control Commands
R&S
®
SMJ100A
643 Operating Manual 1403.7458.32 ─ 14
Parameters:
<OnTime> integer
Range:
1 to 16777215
*RST: 1
Default unit: symbol
Example: BB:DM:TRIG:OUTP2:ONT 20
sets an ON time of 20 symbols for marker 2
Manual operation: See "Marker x" on page 365
[:SOURce<hw>]:BB:DM:TRIGger:OUTPut<ch>:PATTern <Pattern>
Sets the bit pattern used to generate the marker signal in the setting
SOURce:BB:DM:TRIGger:OUTPut:MODE PATTern
. 0 is marker off, 1 is marker on.
Parameters:
<Pattern> integer
Range:
#B0,1 to #B111...1,32
*RST: #B,1
Example: BB:DM:TRIG:OUTP2:PATT #B000000011111111,15
sets a bit pattern.
BB:DM:TRIG:OUTP2:MODE PATT
activates the marker signal according to a bit pattern on output
MARKER 2.
Manual operation: See "Marker x" on page 365
[:SOURce<hw>]:BB:DM:TRIGger:OUTPut<ch>:PULSe:DIVider <Divider>
Sets the divider for Pulse marker mode (
SOUR:BB:DM:TRIGr:OUTP:MODE PULSe
).
The resulting pulse frequency is derived by dividing the symbol rate by the divider.
Parameters:
<Divider> integer
Range:
2 to 1024
*RST: 2
Example: BB:DM:TRIG:OUTP2:PULS:DIV 2
sets the divider to 2 for the marker signal on output MARKER 2.
BB:DM:TRIG:OUTP2:FREQ?
queries the resulting pulse frequency of the marker signal.
Response: 66 000
the resulting pulse frequency is 66 kHz.
Manual operation: See "Marker x" on page 365
SOURce Subsystem