R&S SMJ100A, Руководство по эксплуатации, Страница: 693 / 874

Remote Control Commands
R&S
®
SMJ100A
677 Operating Manual 1403.7458.32 ─ 14
Example: BB:MCCW:CARR:SPAC 10 MHz
sets a carrier spacing of 10 MHz.
Manual operation: See "Carrier Spacing" on page 427
[:SOURce<hw>]:BB:MCCW:CARRier:STATe <CarrierIndex>, <State>
Switches the selected carrier on or off.
The counting in remote control differs from the numbers in the carrier table. Index 0
corresponds to number 1 (first line) in the table. Therefore, switching the state of the
channel via remote control always switches the state of <channel index> + 1 in the
table.
Parameters:
<CarrierIndex> integer
Range:
0 to lastCarrier
<State> select
*RST:
0
Example: BB:MCCW:CARR:STAT 15, ON
switches carrier 16 on.
Manual operation: See "Carrier Table" on page 429
[:SOURce<hw>]:BB:MCCW:CFACtor <CFactor>
Sets the desired crest factor for the multi carrier signal on selection of the command
SOUR:BB:MCCW:CFAC:MODE SLOW
.
Parameters:
<CFactor> float
Range:
0 to 30
Increment: 0.01
*RST:
3
Example: BB:MCCW:CFAC:MODE SLOW
sets the Target Crest optimization mode.
BB:MCCW:CFAC 10 dB
sets the desired crest factor to 10 dB.
Manual operation: See "Desired Crest Factor" on page 428
[:SOURce<hw>]:BB:MCCW:CFACtor:ACTual?
Queries the actual Crest Factor for
BB:MCCW:CFAC:MODE SLOW
.
SOURce Subsystem