R&S SMJ100A, Руководство по эксплуатации, Страница: 596 / 874

Remote Control Commands
R&S
®
SMJ100A
580 Operating Manual 1403.7458.32 ─ 14
Parameters:
<State> 0 | 1 | OFF | ON
*RST:
0
Example: SOURce:AWGN:STATe ON
Manual operation: See "State - AWGN" on page 295
7.16.3 SOURce:BB Subsystem
This subsystem contains all commands for digital signal generation. It is divided into
several subsystems which are described separately.
OUTPut<ch>
The numeric suffix to
OUTPut
distinguishes between the available markers.
EXTernal<ch>
The numeric suffix to
EXTernal
distinguishes between the available external trigger
inputs.
● SOURce:BB Subsystem General Commands ...................................................... 580
● SOURce:BB:ARB Subsystem ...............................................................................580
● SOURce:BB:DM Subsystem .................................................................................629
● SOURce:BB:GRAPhics Subsystem ......................................................................666
● SOURce:BB:IMPairment Subsystem ....................................................................669
● SOURce:BB:MCCW Subsystem ...........................................................................672
● SOURce:BB:MEASurement Subsystem ...............................................................692
● SOURce:BB:POWer Subsystem ...........................................................................695
● SOURce:BB:PROGress Subsystem General Commands ....................................696
7.16.3.1 SOURce:BB Subsystem General Commands
The following section describes the commands for setting the frequency shift and the
phase offset for the signal at the "Baseband" block output.
7.16.3.2 SOURce:BB:ARB Subsystem
The ARB subsystem contains the commands for setting the ARB Generator. Settings
for clock and trigger interfaces and for external outputs are entered in the
SOURce:INPut
and
SOURce:OUTput
subsystems.
Section Chapter 7.4, "Waveform and List Format" , on page 490 describes the ARB
waveform format and how it is used to transmit waveforms via the IEC bus.
● Common Settings ..................................................................................................581
● Clock Settings ....................................................................................................... 581
● Trigger Settings .....................................................................................................583
● Marker Settings .....................................................................................................591
SOURce Subsystem