R&S SMJ100A, Руководство по эксплуатации, Страница: 597 / 874

Remote Control Commands
R&S
®
SMJ100A
581 Operating Manual 1403.7458.32 ─ 14
● Test Signals Settings ............................................................................................ 593
● SOURce:BB:ARB:MCAR Subsystem ................................................................... 596
● SOURce:BB:ARB:WAV Subsystem ......................................................................611
● SOURce:BB:ARB:WSEG Subsystem ...................................................................618
Common Settings
[:SOURce<hw>]:BB:ARBitrary:PRESet
............................................................................ 581
[:SOURce<hw>]:BB:ARBitrary:STATe
..............................................................................581
[:SOURce<hw>]:BB:ARBitrary:PRESet
Sets all ARB generator parameters to their default values.
Example: SOURce1:BB:ARB:PRESet
Usage: Event
Manual operation: See "Set To Default" on page 374
[:SOURce<hw>]:BB:ARBitrary:STATe <State>
Activates the standard and deactivates all the other digital standards and digital modu-
lation modes in the same path.
You have to selecta an waveform first.
Parameters:
<State> 0 | 1 | OFF | ON
*RST:
0
Example: SOURce1:BB:ARBitrary:WAV:SELect 'wave1'
loads waveform file from the default directory.
SOURce1:BB:ARBitrary:TRIGger:SEQ RETR
sets trigger mode Retrigger.
SOURce1:BB:ARBitrary:STATe ON
switches on the ARB generator. The selected waveform is out-
put straight away. A trigger event causes restart.
Manual operation: See "State (ARB)" on page 374
Clock Settings
[:SOURce<hw>]:BB:ARBitrary:CLOCk
............................................................................. 581
[:SOURce<hw>]:BB:ARBitrary:CLOCk:MODE
...................................................................582
[:SOURce<hw>]:BB:ARBitrary:CLOCk:MULTiplier
.............................................................582
[:SOURce<hw>]:BB:ARBitrary:CLOCk:SOURce
................................................................583
[:SOURce<hw>]:BB:ARBitrary:CLOCk <Clock>
The command sets the clock rate in samples. Loading a waveform waveform
(
ARB:WAV:SEL <name>
) sets the clock rate that is defined in the waveform tag 'clock'.
The command subsequently changes the clock rate; see data sheet for value range.
SOURce Subsystem