R&S FSW Series, Руководство пользователя

Страница: 63 / 1450

Getting Started
R&S
®
FSW
63 User Manual 1173.9411.02 ─ 43
SYNC TRIGGER
The SYNC TRIGGER connector can also be used to synchronize the reference fre-
quency on several devices (see
Chapter 5.2.2.12, "SYNC TRIGGER OUTPUT/
INPUT" , on page 60).
5.3 Trying Out the Instrument
This chapter introduces the most important functions and settings of the R&S FSW
step by step. The complete description of the functionality and its usage is given in the
R&S
FSW User Manual. Basic instrument operation is described in Chapter 5.4, "Oper-
ating the Instrument" , on page 81.
Prerequisites
●
The instrument is set up, connected to the mains system, and started up as descri-
bed in
Chapter 5.1, "Preparing for Use" , on page 24.
For these first measurements, you use the internal calibration signal, so you do not
need any additional signal source or instruments. Try out the following:
● Measuring a Basic Signal ........................................................................................63
● Displaying a Spectrogram .......................................................................................65
● Activating Additional Measurement Channels .........................................................67
● Performing Sequential Measurements ....................................................................70
● Setting and Moving a Marker .................................................................................. 71
● Displaying a Marker Peak List .................................................................................72
● Zooming into the Display .........................................................................................73
● Zooming into the Display Permanently ................................................................... 76
● Saving Settings ....................................................................................................... 79
● Printing and Saving Results ....................................................................................80
5.3.1 Measuring a Basic Signal
We will start out by measuring a basic signal, using the internal calibration signal as
the input.
To display the internal 64 MHz calibration signal
1. Press the [PRESET] key to start out in a defined instrument configuration.
2. Press the [Setup] key on the front panel.
3. Tap the "S Support" softkey.
4. Tap the "Calibration Signal" tab.
Trying Out the Instrument