Chapter 3: FRU Removal and Replacement Procedures
Replacing the Node Integrated Storage Controller
Quantum DXi6900-S Field Service Manual
105
1. Holding the card by its edges, position the card so that the connector on the expansion card aligns with
the expansion card connector on the riser (see
Figure 69 on the previous page
).
2. Insert the card-edge connector firmly into the expansion card connector until the card is fully seated.
3. Replace the expansion card latch.
Note:
To install a full length card, use the supports provided on the cooling shroud.
4. If applicable, connect any cables to the expansion card.
5. Install the expansion card riser (see
).
Opening and Closing the Node on page 63
).
Turning On the DXi6900-S on page 20
).
8. Run
Factory Detect Hardware
from the
Service Menu
to detect the new hardware (see
).
9. In the remote management console, delete any administrative alerts and close any service tickets.
Note:
Installation of new Fibre Channel cards will change the world wide name (WWN). Review
and modify SAN zoning and tape library host mappings as needed.
Replacing the Node Integrated Storage
Controller
This section describes how to remove and replace the integrated storage controller in the DXi6900-S Node
and contains the following sections:
l
Obtaining a Replacement Integrated Storage Controller below
l
Replacing the Integrated Storage Controller on the next page
Obtaining a Replacement Integrated Storage Controller
Before beginning the replacement procedure, make sure that you have the required replacement kit. The
appropriate replacement integrated storage controller will be provided by Quantum Customer Support (see
).
You will need the following items to perform this procedure:
l
Replacement integrated storage controller kit provided by Quantum Customer Support.
l
ESD grounding wrist strap (included in the replacement kit)
