Chapter 3: FRU Removal and Replacement Procedures
Replacing the Node Integrated Storage Controller
Quantum DXi6900-S Field Service Manual
106
Figure 70:
DXi6900-S Node Integrated Storage Controller
Illustration
Description
Replacement integrated storage controller (Dell PERC H730)
Replacing the Integrated Storage Controller
This section describes how to remove and replace the integrated storage controller in the DXi6900-S Node.
Caution:
Use appropriate ESD precautions, including the use of a grounding strap, when performing
this procedure.
Removing and replacing the integrated storage controller in the Node includes the following steps:
l
Identifying a Failed Integrated Storage Controller below
l
Removing a Failed Integrated Storage Controller on the next page
l
Replacing the Node Integrated Storage Controller on the previous pageInstalling a Replacement
Integrated Storage Controller on page 109
l
Replacing the Node Integrated Storage Controller on the previous page
Identifying a Failed Integrated Storage Controller
The DXi6900-S Node contains an integrated storage controller (Dell PERC H730) that supports the SAS
solid state drives in the Node.
To identify a failed integrated storage controller:
1. Access the remote management console (see
Accessing Remote Management on page 21
).
2. Navigate to the
Status > Hardware > Details > Storage Arrays
page.
3. Under
Storage Arrays
, click
PERC H730 Mini (Embedded)
, and then note the status of the PERC
).