Additional information
137
En
17
Front panel displays
The table below shows a list of error messages that you may encounter when using the
recorder and an explanation of their meaning.
• Could not operate the DV camcorder.
This recorder was not able to operate the DV
camcorder.
• The DV camcorder is not set for
playback. Please select playback mode
on the DV camcorder.
The camcorder is in camera mode. Switch it to
playback mode.
• The printer is not ready or is not
connected. Please check the printer.
This message is displayed when communication
could not be established with the printer. See the
Troubleshooting
section if you do not know the cause.
• Printing has been cancelled
because ...
This message is displayed when there is a printer
error during printing. After checking the printer for
the cause of the error, either reconnect the printer
and start the printing job again, or select “Yes” to
resume printing (select “No” to cancel the print
job). See also the operating instructions that came
with your printer for possible causes of print errors.
Message
Explanation/Action
• E01
The HDD may be damaged or broken. Please ask your nearest Pioneer-
authorized service center or your dealer to carry out repairs.
• E02
As the HDD info cannot be properly read, no new recordings can be made.
Reinitializing the HDD (page 109) may result in your being able to make recording
again. Note that reinitializing the HDD will erase all recorded contents, including
protected files.
• HDCP ERR
Displayed when a device that is not HDCP-compatible is connected to the
HDMI terminal. Connect a device that is HDCP-compatible.
Some components that are compatible with HDCP still cause this message to
be displayed, but so long as there is no problem with displaying video this is not
a malfunction.
Message
Explanation/Action
18 Additional_Information.fm 137 ページ 2008年2月22日 金曜日 午後8時44分