OPTIMedical OPTI CCA-TS, Руководство оператора, Страница: 95 / 271

5-6 Operator’s Manual – OPTI CCA-TS
5 SAMPLE HANDLING AND PATIENT TESTING
• Press the cover release button to open the
Sample Measurement Chamber (SMC)
(Fig. 5-4).
NOTE: If using the same lot number of cassette as
the previous patient sample, the cassette
information may be recalled by pressing
the <Last Entry> button in the <Ready>
screen. The analyzer will then identify the lot
number, and prompt you to open the cover,
wipe and insert the cassette and close the
cover.
• Enter your Operator ID or four (4) digit
PIN # if requested.
4. Insert the cassette as follows:
• Open the OPTI Sensor Cassette packet and
remove the cassette from the pouch
(Fig. 5-5). After opening the pouch, proceed
with the following steps immediately.
NOTE: The cassette should be run immediately after
opening the pouch, but no later than 15
minutes after opening.
NOTE: For sample introduction with a capillary
tube or a ComfortSampler, remove the
syringe adapter before placing the cassette
into the chamber.
NOTE: If possible avoid tearing the bar code when
opening the cassette pouch.
• Gently wipe both sides of the cassette with a
clean dry cloth to remove excess moisture.
• Insert the cassette in the chamber.
Press down to ensure the cassette is properly
seated (Fig. 5-5).
• Close the SMC cover by pressing it down
firmly (Fig 5-6).
• The green status light starts to blink
indicating that the SMC cover should not be
opened during this time.
NOTE: If the SMC cover is opened while the
green status light is blinking, the cassette
calibration will be cancelled and the
cassette must be discarded.
Fig. 5.5 Open Cassette Packet
and Insert Cassette
Fig. 5-4 Open SMC Cover
Fig. 5-6 Close Cover