OPTIMedical OPTI CCA-TS, Руководство оператора, Страница: 81 / 271

4-10 Operator’s Manual – OPTI CCA-TS
4 CALIBRATION AND QUALITY CONTROL
Fig. 4-19 Insert Cassette
Fig. 4-18 Open Cover
Fig. 4-17 Scan Bar Code
6. Scan the bar-coded strip on the OPTI Cassette
package by holding it 2-3 inches (5-8 cm) from
the bar code scanner located on the bottom right-
hand corner of the analyzer to automatically
record the lot and calibration information for the
specific cassette (Fig. 4-17).
• The red line from the barcode scanner
should cover the entire bar code.
• The unit will beep and the status light will
turn green to confirm a valid bar code.
• In case of an expired cassette, the light will
turn red.
NOTE: Refer to special handling instructions inside
the cassette box for refrigerated cassettes.
NOTE: If the bar code is damaged or unreadable,
press
<Manual Entry>
and enter the bar
code digits printed on the bar code label
using the numeric keypad.
NOTE: A control measurement may be made using
any cassette lot or cassette type.
7. Open the sample chamber cover by pressing the
release button (Fig. 4-18) .
8. Tear open the cassette pouch being careful not
to tear the bar code. Remove the cassette and
wipe any excess moisture from the cassette with
a clean dry cloth.
NOTE: If the QC sample is to be introduced with a
capillary tube, remove the syringe adapter
before placing the cassette into the chamber.
9. Insert the cassette into the chamber.
Press down to ensure that the cassette is seated
properly (Fig. 4-19).
NOTE: Run cassettes immediately after opening
pouch, if possible, but no later than 15
minutes after opening the pouch.