Mitsubishi 13J851, Руководство пользователя

Страница: 265 / 270

252
7032
• The number of CPU modules
mounted in a multiple CPU system is
wrong.
Configure a system so that the number
of mountable modules of each CPU
module does not exceed the maximum
number of mountable modules specified
in the specification.
Q00/Q01
*1
QnU
7035
The CPU module has been mounted on
the inapplicable slot. Mount the CPU module on the
applicable slot.
Q00J/Q00/
Q01
*1
QnPRH
QnU
7036
The host CPU No. set by the multiple
CPU setting and the host CPU No.
determined by the mounting position of
the CPU module are not the same.
• Mount the mounting slot of the CPU
module correctly.
• Correct the host CPU No. set by the
multiple CPU setting to the CPU No.
determined by the mounting position
of the CPU module.
QnU
*3
8031
The error of stored file (enabled
parameter file) is detected.
Write the file shown as SD17 to SD22 of
individual information to the drive shown
as SD16(L) of individual information,
and turn ON from OFF the power supply
of the CPU module or cancel the reset.
If the same error is displayed again, the
CPU module has hardware failure.
Contact your local Mitsubishi
representative, explaining a detailed
description of the problem.
QnU
9000 Annunciator (F) was set ON
Read the individual information of the
error using the peripheral device, and
check the program corresponding to the
numerical value (annunciator number).
9010 Error detected by the CHK instruction.
Read the individual information of the
error using the peripheral device, and
check the program corresponding to the
numerical value (error number) there. QnA
Qn(H)
QnPH
QnPRH
9020
Storage of data onto ROM was
completed normally in automatic write
to standard ROM.
(BOOT LED also flickers.)
Use the DIP switches to set the valid
parameter drive to the standard ROM.
Then, switch power on again, and
perform boot operation from the
standard ROM.
Qn(H)
*1
QnPH
QnPRH
10000
In the multiple CPU system, an error
occurred in the CPU module other than
the Process CPU/High Performance
model QCPU.
Check the details of the generated error
by connecting to the corresponding
CPU module using GX Developer.
Qn(H)
*1
QnPH
Error
Code
(SD0)
Error Contents and Cause Corrective Action
Corresponding
CPU
*3 The Universal model QCPU except the Q02UCPU.