Mitsubishi 13J851, Руководство пользователя

Страница: 235 / 270

222
*1 The module whose first 5 digits of serial No. is 09012 or later.
Error
Code
(SD0)
Error Contents and Cause Corrective Action
Corresponding
CPU
6000
The control system and standby system
in the redundant system do not have
the same programs and parameters.
(This can be detected from the standby
system of the redundant system.)
Synchronise the programs and
parameters of the control system and
standby system.
Q4AR
In a redundant system, the control
system and standby system do not
have the same programs and
parameters.
The file type detected as different
between the two systems can be
checked by the file name of the error
common information.
• The program is different.
(File name = ********.QPG)
• The PLC parameters/network
parameters/redundant parameters
are different.
(File name = PARAM.QPA)
• The remote password is different.
(File name = PARAM.QPA)
• The intelligent function module
parameters are different.
(File name = IPARAM.QPA)
• The device initial values are different.
(File name = ********.QDI)
• The capacity of each write destination
within the CPU for online pchange of
multiple program blocks is different.
(File name = MBOC.QMB)
(This can be detected from the standby
system of the redundant system.)
• Match the programs and parameters
of the control system and standby
system.
• Perform PLC verify in either of the
following procedures 1), 2) to clarify
the differences between the files of
the two systems, then correct the
wrong file, and write the corrected file
to the PLC again.
1) After reading the programs/
parameters of System A using
GX Developer or PX Developer,
verify them with those of System B.
2) Verify the programs/parameters of
GX Developer or PX Developer
saved in the offline environment
with those written to the CPU
modules of both systems.
• When the capacity of each write
destination within the CPU for online
change of multiple program blocks is
different between the two systems,
take corrective action 1) or 2).
1) Using the memory copy from control
system to standby system, copy the
program memory from the control
system to the standby system.
2) Format the CPU module program
memories of both systems. (For the
capacity of each write destination
within the CPU for online change of
multiple program blocks, set the
same value to both systems.)
QnPRH