Strip and Bus Tools
13 - 137
Ramses MSC reference guide
Strip and Bus Tools : Strip and Bus Tools
Grouped controls are indicated by a yellow
L
in the corner of the control ‘block’.
Factor X Slider
Works only on continuous (rotary or linear) controls. It determines the gearing
of this control in relation to other members of the group and vice versa. E.g,
assume the input gain of strip tools #1 and the input gain of strip tools #2 are
both assigned to group one. The scale factor of the gain of strip tools #2 is set
to 2. Now when you change the gain of strip tools #1 by 1 dB, the gain of strip
tools #2 will change by 2 dB’s.
Invert
Also works only on continuous controls. It inverts the effect of the movement
for this control caused by another group member or vice versa. E.g, assume
the input gain of strip tools #1 and the input gain of strip tools #2 are both
assigned to group one. The invert button of the gain of strip tools #2 is on. Now
when you increase the gain of strip tools #1 by 1 dB, the gain of strip tools #2
will diminished by 1 dB.
Automation mode switches
When a grouped control is clicked, all other members of the group are shown with a yellow box around
them.
Offset
If controls are offset when grouping is turned on, they retain the offset as shown here.
The red bar at the top of the strip indicates it is selected. The grayed out knob is the one which was right-
clicked.
Strip Tools - Grouped Controls
Strip Tools - Grouped Knobs
