Introduction
1 - 11
Ramses MSC reference guide
Introduction : The Basics
The Basics
How to turn your Ramses On
Assuming the Console has been correctly installed and is plugged into mains power, simply press the
black 'ON' button to power on the console. The switch can be found on the rear panel on the left-hand side
when viewed from the back:
The boot process takes approximately one to two minutes.
How to turn your Ramses Off
Press the
SYSTEM
Button on the Upper Active Panel, then press the
SHUTDOWN
Touch Button then con-
firm by pressing the
CONFIRM
Touch Button.
How to load your project
Once your Ramses has booted, you will be able to load a project in Pyramix and start mixing.
Note:
it is important that the console is fully powered up before you load your project.
The Pyramix project you load will determine the number and type of the features you will be able to map to
your Ramses. For example, the number of mixer strips, tracks and plugins, whether there is a monitoring
section etc.
At any time you may add or remove strips, tracks, buses, plugins etc. and the Ramses will reconfigure in
seconds.
Tips and tricks
We strongly recommend setting up some templates on your Pyramix/Masscore that include everything you
need in your day to day work, since MassCore has tremendous power (256 I/O and 256 Busses). This will
avoid the inconvenience of mixer rebuilds. Treat the Ramses as you would a normal, fixed architecture con-
sole with a full complement of Dynamics, EQ's and effects etc. and just switch the functions on as you need
them.
POWER SWITCH
Power Switch
