![background image](http://html1.mh-extra.com/html/magnetek/rcp/rcp_user-manual_3581075025.webp)
RCP User’s Guide
July 2017
Page 25 of 110
Field
Description
Serial Number
This section displays the serial number for the unit.
The serial number of the unit is set by the factory and cannot be modified by the
user.
Access Code
The access code acts as the receiver address. The receiver will only listen to
transmitters with the same access code.
NOTE: The transmitter must be set with the same access code as the receiver to
properly communicate with each other.
Range: 1-1048575
RF Channel
The RF channel is user-selectable through the pull-down menu. This function is
used to prevent interference with other radio devices.
Refer to Section 6 for additional information on channels and the exact frequency
for each frequency range.
Depending upon the installation, there might be special frequency channels
shown.
Inactivity Timeout
The amount of time (in minutes) the unit will stay powered on if there is no user
input.
Range: 0 – 60 (zero indicates no timeout, and the unit will stay on indefinitely).
RF Power
Power level of the RF transmission (Full/Half/Quarter/Minimum).
Activate Password
The password is used to restrict access to the configuration menu on the device.
Having an active password prevents accidental changes to the device
configuration.
NOTE: Please familiarize yourself with this section before programming the
password.
The password default setting is to be disabled during initial programming by the
RCP software. To enable password protection, check the box next to the phrase
“Activate Password.”
If you choose to enable the password function, you can create a new password by
selecting a four-digit numerical password using numbers from 0 to 9. Be sure to
write this password down in a safe place for future reference.
Update Date/Time
The user can match the device time to the PC’s time or choose to set a time other
than the time on the PC.
Battery Pack Type
Allows the user to configure the battery pack type. The choices are rechargeable
and alkaline. If the device supports the feature, then the drop-down box is
enabled. Devices with updated firmware to support this feature may not have the
option to select the pack type and the RCP control will be read-only. Older
firmware will be reported as feature is not supported.
This feature is only available for the Flex VUE and Mini-PGT/Mini-MBT and must
have updated device firmware to read/write this configuration parameter. For Flex
VUE the common code needs to be v4.1 or greater.
For Mini-PGT/Mini-MBT the common code needs to be v2.1 or greater.
Table 2. Transmitter Info Field Descriptions
This information can be read from and written to the devices that support USB communications using a
USB cable connected between the PC's USB port and the USB port on the device. Refer to the product-
specific manual for USB port locations. Once the connection has been made and the device is powered
on, the device name will appear in the tool bar.
Содержание RCP
