![background image](http://html1.mh-extra.com/html/magnetek/rcp/rcp_user-manual_3581075048.webp)
RCP User’s Guide
July 2017
Page 48 of 110
moved and one of the channels could be moved out of the
workspace.
Crtl+S
Saves the project.
Ctrl+(Left Mouse Click)
Adds the clicked channel to the selected group if the
channel is not in the group. Removes the clicked channel
from the selected group if the channel is selected.
8.2.4 Programming Tab Button Functions
Figure 14: Functions Available on the Programming Tab
“Compiled” Button
– This button compiles the channel paths so they can be sent to the device.
“Use Default Map” Button
– Used only with the in
tele
Smart2 receiver. This button sends the receiver
into a default mapping mode that is embedded into the device’s firmware file.
“Align Selected” Button
– Aligns the selected channels to the left most channel in the group. This only
works if there are multiple channels selected.
“Clear Workspace” Button
–
Removes
all of the channels from the workspace. Data will be lost as soon
as the project is saved.
8.2.5 Channel Selection Tab Groups
NOTE: Not all channel types are available for all devices. Refer to Section 9.1.4 for specifics on each
device.
The property grid on the right changes based on what type of channel is selected in the workspace area.
When the programming tab page is active, channels can be added to the workspace by clicking on the
channels displayed on each of the tabs.
Figure 15: RF Message Channels
8.2.6 Receiver User Interface
There will be a new channel added to RCP and supporting device firmware to support feedback. This
channel will allow data to be sent back to the transmitter.
Содержание RCP
