![background image](http://html1.mh-extra.com/html/magnetek/rcp/rcp_user-manual_3581075042.webp)
RCP User’s Guide
July 2017
Page 42 of 110
Figure 7: CAN Bus Configuration Page (CAN-2)
CAN Field
Description
Source Address
This is the address that the device will use as the source address when
transmitting messages on the CAN bus network.
Baud Rate
This pull-down menu allows the user to modify the communication speed of
the CAN bus network. The user-selectable options are 50k, 125k, 250k, and
500k.
Protocol Type
The protocol used to communicate on the CAN bus.
Options: J1939/CAN Open/Parker ICP/High Country Tek DN/OEM Controls
DN
NOTE: Not currently supported by any product.
Identifier
The number of bits in the frame.
Options: 11 bits/29 bits
NOTE: Not currently supported by any product.
Terminating
Resistor
Selects whether an internal terminating resistor or an external terminating
resistor is used. Selecting internal will enable the terminating resistor.
Selecting external will disable the internal terminating resistor.
NOTE: Not all devices have the termination resistor set via software. This
setting is only applicable to the devices that have this set via software. Please
refer to the instruction manual for your device to determine how this setting
can be modified.
Options: Internal/External
Enable PGN 65410
Enable/Disable Status PGN 65410 (Available in CAN-2 only)
Enable PGN 65411
Enable/Disable Status PGN 65411 (Available in CAN-2 only)
Enable PGN 65412
Enable/Disable Status PGN 65412 (Available in CAN-2 only)
Enable PGN 65413
Enable/Disable Status PGN 65413 (Available in CAN-2 only)
Содержание RCP
