![background image](http://html1.mh-extra.com/html/magnetek/rcp/rcp_user-manual_3581075043.webp)
RCP User’s Guide
July 2017
Page 43 of 110
CAN Field
Description
Enable PGN 65414
Enable/Disable Status PGN 65414 (Available in CAN-2 only)
Enable PGN 65415
Enable/Disable Status PGN 65415
Enable PGN 65416
Enable/Disable Status PGN 65416
Table 7. CAN Configuration
8.1.3 Analog Input Configuration
For devices with configurable analog inputs, the following properties are configurable through the property
grid if one of the analog inputs is selected:
Analog Field
Description
Input Type
(Analog/Digital)
Digital – the voltage on the input will be represented as a digital value
based on the thresholds.
Analog – the voltage on the input will be represented as its 10-bit analog
value.
On Threshold
Digital (voltages above this value will be a digital high)
Off Threshold
Digital (voltages below this value will be a digital low)
Minimum Voltage
Analog (the minimum operating voltage of the device connected to the
input)
Maximum Voltage
Analog (the maximum operating voltage of the device connected to the
input)
Table 8. Analog Input Configuration
NOTE: The range for the analog input pins are 0-13.2 volts.
8.2 Programming Tab
The Programming tab page allows the user to map inputs and outputs in the device. The physical inputs
can be mapped to physical outputs on the device; alternatively, a user can perform a mathematical
operation on the input and then direct the result of the mathematical operation to an output channel. For
specifics on programming each type of device, please refer to Section 9.
NOTE: The device must be running a specific version of the hex file for it to accept and run the program
created for it. There are special versions of firmware for the receivers that permit RCP-created mappings
to be loaded on the product. Refer to Section 5.2.6 for information on where to locate these firmware files.
These files are loaded via FDP. Refer to Section 5.2.2 for instructions on how to update the firmware.
Содержание RCP
