![background image](http://html1.mh-extra.com/html/magnetek/rcp/rcp_user-manual_3581075038.webp)
RCP User’s Guide
July 2017
Page 38 of 110
Field
Description
Frequency
A read-only property displaying the radio frequency of the device. This is set
by the factory and hardware configuration, and cannot be modified by the
user.
Access Code
The access code acts as the receiver address. The receiver will only listen to
transmitters with the same access code.
NOTE: The transmitter must be set with the same access code as the
receiver to properly communicate with each other.
Range: 1-1048575
RF Channel
The RF channel is user-selectable through the pull-down menu. This function
is used to prevent interference with other radio devices.
Refer to Section 6 for additional information on channels and the exact
frequency for each frequency range.
Depending upon the installation, there might be special frequency channels
shown.
RF Antenna
This section allows the user to select between utilizing the internal antenna
that is built into the receiver or utilize the external antenna attachment (if
available).
The antenna selection can be internal or external (if supported).
Rx Timeout
The amount of time before the device shuts down after not receiving a
message from the transmitter.
Range: 450-3000 ms
Client/Server
The operation mode of the WIC-2402 device. This field maybe read-only if the
device is pre-defined.
Device Name
The device name field allows the user to create a custom name for the
receiver.
The name can be up to 16 ASCII characters long.
Project ID
This section displays the project ID for the device.
The project ID is set by the factory and cannot be modified by the user.
Range: 1-65535
Serial Number
This section displays the serial number for the unit.
The serial number of the unit is set by the factory and cannot be modified by
the user.
Device Memory
Used
A read-only property showing the percentage of memory allocated for custom
mapping.
Expansion Board 1
A read-only field that displays the type of expansion board that is connected.
Expansion Board 2
A read-only field that displays the type of expansion board that is connected.
Program Loaded
A read-only property showing if a user-defined map is loaded in the system.
Содержание RCP
