![background image](http://html1.mh-extra.com/html/magnetek/rcp/rcp_user-manual_3581075020.webp)
RCP User’s Guide
July 2017
Page 20 of 110
5.3 Device Programming
5.3.1 Sending Device Configuration
WARNING
AFTER EVERY PROGRAMMING OF THE RECEIVER, TEST THE UNIT BY UTILIZING THE APPROPRIATE
TRANSMITTER. IF THE RECEIVER DOES NOT RESPOND, DO NOT ACTIVATE A FUNCTION BUTTON!
THE RECEIVER MAY HAVE INCORRECT PROGRAMING. RE-CHECK THE PROGRAMMING IN THE RECEIVER
AND RETEST. AFTER ACTIVATION OF THE RECEIVER, FUNCTIONALLY TEST ALL COMMANDS ON THE
TRANSMITTER BY INITIALLY JOGGING THE BUTTONS, WITH A FULL MOVEMENT, BEFORE RETURNING TO
SERVICE. FAILURE TO FOLLOW THIS WARNING COULD RESULT IN SERIOUS INJURY OR DEATH AND
DAMAGE TO EQUIPMENT.
NOTE: The device configuration can also be read to and written from transmitters using the IR adapter
when the USB interface is not permitted to be used. Currently the IR adapter does not support reading
and writing to the receivers, except for the inteleSmart receivers.
To send a program file to a device:
1. Plug in the USB programming cable or position.
NOTE: Reference the specific device manual for details on connecting the USB cable.
2. Click the “Send” button on the RCP screen. A dialog box will pop up confirming that you want to
proceed. Check the box marked “I accept,” select the data you wish to send to the device, and
then click the button “Continue Send to Radio.” On-screen prompts will confirm that the receiver
has been programmed or notify you if there are any issues.
If you hover over the check box or text a tooltip will appear detailing the data that will be transferred from
the device to the RCP project. Clicking “Cancel” will close the pop-up, will not transfer any data, and the
project will open to its default values.
Содержание RCP
